ESP8266 NodeMCU Mac installation port issue??? Update oct 11!!!!! I have installed the driver from the link below that was left. But still nothing. See uninstalling information at the bottom of the page if the driver causes problems for you. Here is an older version of the Mac driver, NOT FOR 10.12 Sierra (V1.0) Download the CH340 Macintosh Signed Driver for Mavericks (10.9), Yosemite (10.10) and El Capitan (10.11). USB Drivers for NodeMCU v1.0. NodeMCU is an open-source firmware and development kit that helps you to prototype or build IoT products. It is based on the lowest cost WI-FI MCU ESP8266, ESP8266 is about $2 and once it comes as NodeMCU easy to prototype development kit you can purchase for about $4 something you can connect to your. The objective of this short post is to explain how to get the MAC address of the ESP8266. Explaining in detail what is a MAC address is outside of the scope of this post. But, just as a quick explanation, the MAC address is a unique value associated with a network adapter 1. I can see hello world on serial monitor. But on my Mac, I can see garbage only. I tried some serial monitors, Arduino IDE and platform io ide but still same. Are there any solution about this problem? EDIT: I fixed issue last night. Catalina has ch340 drivers already and I setup oem driver from GitHub. Apples driver and oem drivers conflicting.
When you connect the WeMOS D1 mini board for the first time on your Windows computer through a USB cable, it might be the case to install a USB-to-SERIAL driver.
The board has a USB-to-SERIAL converter (CH340 chip).
The driver is available for download here.
Install the driver
To make sure that is ok, check the “Device Manager” to see if your port is available and note the port number (in my case, COM6)
Esp8266 Mac Driver Free
In Arduino IDE make sure to select the proper COM port
If you can compile and upload an empty sketch, you’re ready for IoT!
Arduino 1.8.9, Windows 10, updatet, Driver for ESP8266 - CH340 - no ports
Having used the Arduino IDE for many years, but apparently today, when I wanted to start a new project, I can't get the Arduino IDE to show the COM ports.
I have tried uninstalling my CH340 Driver and reinstalled it. It went fine, but there are still no com ports available.
Have tried on another Windows 10 PC which I have also used before with Arduino IDE, but same problem here. No COM ports
Maybe it's due to the latest Windows 10 update, but I really have no idea what's wrong?
 - Twins Chip 1-550x550w.jpg "High")
Esp8266 Mac Driver
Hope someone has experienced the same and may have some tips ...